Reliable tools for efficient surveys
With more than forty years of field experience, we know the importance of reliable, compatible, easy-to-use tools for specific survey needs. Zonge geophysical data acquisition equipment includes all the tools you need for efficient data collection.
MX-30 Transmitter Input Multiplexor Switch
for Cabled Electrode Arrays
An essential component for rapidly acquiring resistivity data using cabled electrode arrays, the MX-30 is a computer-controlled switching interface between a transmitter, a multi-channel receiver (such as the Zonge GDP) and an array of electrodes. Weight: 16 kg (35 lb).
- Use an MX-30 multiplexor with a GDP receiver and ZT-30 transmitter to gather Electrical Resistivity Tomography data.
- Connect transmitter leads to any pair of electrodes, up to 30 electrodes.
- Select any number of electrode pairs for input to the receiver.
- Up to 16 output channels, or purchase fewer channels to reduce initial cost and upgrade later in the field.
- Cascade multiple MX-30s together to address multiple electrode arrays.
- Control configuration via RS-232C serial communications.
- Control software available for laptop.
LB2500 Load Bank
Resistor load bank, including fuses, 2.5 KVA. Weight: 13.2 kg (29 lb).
Potential electrode buffer amplifier (unity gain) for multiple, in-line electric field measurements. Used when line capacitance influences the frequency response, as in areas of high contact resistance and/or long dipole lengths. Weight, each with batteries: 0.5 kg (1 lb).
ISO/1 Isolation Amplifier
This isolation amplifier serves as a transmitter-current monitor when making referenced CR measurements. Self-contained power supply with battery. Includes one input signal cable, one output signal cable, battery charger, and five 3AG 1/2A fuses for each unit. Weight with batteries: 4 kg (9 lb).
ZCM-10 Current Monitor
The ZCM-10 current monitor replaces the ISO/1. It serves as as a transmitter current monitor. Self-contained power supply with battery.
A “calibrate load” used to generate standard decay curves for TEM and NanoTEM systems as a check for system operation. Weight: 0.5kg (l lb).
MULT/SY-32 Connection Box
Connection box for synchronizing one XMT-32 transmitter to GDP receivers and SC-8 signal conditioning boxes (up to 4 total). Weight: 1.2 kg (2.5 lb).
External 12-volt battery pack for the MX-30 electrode multiplexer and 12/24-volt battery pack for the NT-20 and ZT-20 TEM transmitters.
MX-Bat Weight: 4.5 kg (10 lb). NTEM-Bat Weight: 8.5 kg (18.5 lb).
Universal input, 12-volt battery charger. Input power specifications: 85-264 VAC, 45-440 Hz or 104-350 VDC. Dual circuits permit charging two 12v batteries simultaneously. UC-2 12v Battery Charger Weight: 4.8kg (10.5 lb).
Powered or manual (hand cranked) wire reels for transport, layout and retrieval of wire for geophysical surveys:
Manual reels may be ordered empty or with 610 meters (2,000 feet) of 14-gauge MTW grade transmitter wire. Seven reels of wire are adequate for a standard 7-electrode, 300 meter dipole-dipole IP survey.
Power reels may be ordered empty or with 1,067 meters (3,500 feet) of 14-gauge MTW grade transmitter wire. Four reels of wire are adequate for a standard 7-electrode, 300 meter dipole-dipole IP survey.
Electrode switch box can be used to connect and switch nine electrodes (eight dipoles)